Hello everyone! Today I am showcasing some products from the new BLOOMING collection by Karin Joan. I made three similar (but still different) cards.
If you want to check out the products yourself...
http://www.karinjoan.nl http://www.studiolight.nl
CARD #1:
I started with an A2 (American size) piece of Neenah 110 lb Solar White Card Stock. Next, I took the STAMPKJ04 and laid out different stamps on the edge of this panel. Next, I stamped them out using Versamark Clear Embossing Ink. The embossing powder I used is from Nuvo (Glacier white). I melted the embossing powder using my heatgun.
In the following step, I took my distress inks (listed below each photo) and blended them from the edge going more towards the middle (softening the pressure and amount of ink).
The finish the card, I needed a sentiment. Therefore, I took the Die Cut Block (A5STANSBLOKKJ01). I took a fitting sentiment and adhered it using Darice Foam Strips. The whole panel was then adhered to an (American) card base with Permanent Pritt Adhesive.
Supplies:
CARD #2:
What changed in supplies?
I just switched up the sentiment and I changed the colors of Distress Ink.
Supplies:
CARD #3:
What changed in supplies?
The sentiment was from the same stamp set as the flowers and leaves. I also changed up the colors used.
Supplies:
If you want to check out the products yourself...
http://www.karinjoan.nl http://www.studiolight.nl
CARD #1:
I started with an A2 (American size) piece of Neenah 110 lb Solar White Card Stock. Next, I took the STAMPKJ04 and laid out different stamps on the edge of this panel. Next, I stamped them out using Versamark Clear Embossing Ink. The embossing powder I used is from Nuvo (Glacier white). I melted the embossing powder using my heatgun.
In the following step, I took my distress inks (listed below each photo) and blended them from the edge going more towards the middle (softening the pressure and amount of ink).
The finish the card, I needed a sentiment. Therefore, I took the Die Cut Block (A5STANSBLOKKJ01). I took a fitting sentiment and adhered it using Darice Foam Strips. The whole panel was then adhered to an (American) card base with Permanent Pritt Adhesive.
Supplies:
- BLOOMING Clear Stamps - STAMPKJ04
- BLOOMING Die Cut Block - A5STANSBLOKKJ01
- Neenah 110 lb Solar White Card Stock
- Versamark Clear Embossing Ink
- Nuvo Embossing Powder - Glacier White
- Distress Inks: Tattered Rose, Dried Marigold
- Darice Foam Strips
- Permanent Pritt Adhesive
CARD #2:
What changed in supplies?
I just switched up the sentiment and I changed the colors of Distress Ink.
Supplies:
- BLOOMING Clear Stamps - STAMPKJ04
- BLOOMING Die Cut Block - A5STANSBLOKKJ01
- Neenah 110 lb Solar White Card Stock
- Versamark Clear Embossing Ink
- Nuvo Embossing Powder - Glacier White
- Distress Inks: Twisted Citron, Cracked Pistachio, Evergreen Bough
- Darice Foam Strips
- Permanent Pritt Adhesive
CARD #3:
What changed in supplies?
The sentiment was from the same stamp set as the flowers and leaves. I also changed up the colors used.
Supplies:
- BLOOMING Clear Stamps - STAMPKJ04
- Neenah 110 lb Solar White Card Stock
- Versamark Clear Embossing Ink
- Nuvo Embossing Powder - Glacier White
- Distress Inks: Seedless Preserves
- Distress Oxide Inks: Seedless Preserves
- Darice Foam Strips
- Permanent Pritt Adhesive
Reacties
Een reactie posten